All times are UTC

 




Post new topic  Reply to topic  [ 1 post ] 
Author Message
 Post subject: Fitting Rear Wings
PostPosted: Mon Dec 31, 2012 6:57 pm 
Offline
User avatar

Joined: Tue Dec 04, 2012 4:04 pm
Posts: 70
Name:
Image
1. Remove the wheel if fitted. Use masking tape where the wing is to sit.


Image
2. Now using a quick action clamp, lightly clamp the wing in rough position.


Image
3.1 Making sure the bottom of the wing lines up with the back panel bottom.


Image
3.2 and bottom of the side panel


Image
4.Put the wheel back on and tweak the wing so its symmetrical front and back


Image
5. Tightly clamp the wing with the quick clamp and check its not moved. Now mark with a pencil around the wing so you have its location permanently marked.


Image
6.Remove wheel. Drill though the lip of the wing into the bodywork at your preferred intervals. I had about 7 fixings on mine which is plenty. I used m6 stainless fixings.


Image
7. Put in temp fixings as you go to stop the wing moving, checking against your pencil marking.


Image
8. Once all the holes are drilled, remove fixings and wing. Remove the masking tape and refit wing. I used "Tadpole" Rubber Trim between the wing and bodywork.

_________________
Ben

Image
http://www.equinoxproducts.co.uk/


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC

 


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron

Copyright 2016: Roadster Builders

 

Powered by phpBB® Forum Software © phpBB Limited