Roadster Builders
http://roadster-builders.co.uk/

MX5 Cooling & Rad
http://roadster-builders.co.uk/viewtopic.php?f=8&t=675
Page 1 of 1

Author:  Dave_F [ Sat Dec 10, 2016 9:00 am ]
Post subject:  MX5 Cooling & Rad

I'm looking at buying a Radiator over the next week or so and was looking at the options. My initial plan is to use an 190e (http://www.ebay.co.uk/itm/122141245444? ... EBIDX%3AIT) I believe it gives better cooling than the polo Rad. Looking at it though it has a top and bottom pipe but no small top pipe. I plan to use a polo header tank that will be T'ed into the back of the engine where the heater matrix would normally be but where would the top 'overflow', if that is actually what it is, go? I hope this all makes sense and I always open to any other options


Sent from my iPhone using Tapatalk

Author:  The V8 Files [ Sun Dec 11, 2016 11:11 am ]
Post subject:  Re: MX5 Cooling & Rad

Another option is the disco rad that Bob is using.

forum/viewtopic.php?p=3110#p3110

Author:  robo [ Sat May 12, 2018 9:48 am ]
Post subject:  Re: MX5 Cooling & Rad

Quote:
Another option is the disco rad that Bob is using.

forum/viewtopic.php?p=3110#p3110
That link is dead now Bruce.

Been looking at the latest offerings and there seems to be a lot of Ali aftermarket replacements about, no doubt of oriental persuasion but seem to well made and competitively priced



https://i.ebayimg.com/images/g/ut8AAOSw ... -l1600.jpg

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/